Figure 64. Shrink Tube Dimensions
111. SHRINK BOOT AND ADAPTER INSTALLA-
Apply heat to boot using HT-900B beat gun,
TION. Upon completion of the connector repair install
to shrink boot to adapter and cable.
the shrink boot and adapter using the following pro-
g. If boot was not salvaged, refer to NAVAIR 01-
1A-505-1, WP 011 01 to fabricate new boot.
a. Install the adapter using tools and tool
procedures (paragraph 100).
112. NON-ENVIRONMENTAL BACKSHELL. A non-
environmental backshell or extender is used when
b. If boot was salvaged, proceed with steps c
moisture entry is not a problem. They are used when
additional space is required for maintenance.
Slide boot to connector.
d. Apply a coat of epoxy glue to the adapter lip
and inside of shrink boot.
114. Straight Backshell with Cable Clamp M85049/
21. This is a straight backshell with a cable clamp. The
Seat boot on adapter lip.
backshell, along with dimensions and part number
breakdown, is illustrated (Figure 65).