NAVAIR 01-1A-505-2
006 02
TO 00-25-255-1
Page 2
TM 1-1500-323-24-2
Record of Applicable Technical Directives
None
Support Equipment Required
Materials Required
Part No./
Nomenclature
Specification/
Nomenclature
Type Designation
Part No.
GS590
Die Set
S1009
Glue, Epoxy
GS710
Die Set
SAE-AMS-DTL-23053
Sleeving, Insulating,
GS840
Die Set
Heat-Shrinkable
GS1010
Die Set
P-2740FR
Tape, Silicone Rubber
GS1130
Die Set
GS1250
Die Set
1. INTRODUCTION.
GS1670
Die Set
GS1920
Die Set
2. This Work Package (WP) pertains to connectors
GS2170
Die Set
manufactured in accordance with MIL-DTL-83723
GS2420
Die Set
Series II.
G82670
Die Set
GS2920
Die Set
NOTE
GS1440
Die Set
HT-900B
Heat Gun
As all NAVAIR connector and accessory
M22520/1-01
Tool, Crimp, Frame
documents are transitioned to non-government
M22520/1-02
Positioner
standards, the Society of Automotive Engineers
M22520-2-01
Tool, Crimp, Frame
(SAE) will become the preparing activity and
AU2520-2-13
Positioner
the Navy will adopt the documents, and the
M22520/3-1
Gage, Inspection
drawing number prefix will change from MS
M22520/7-01
Tool, Crimp, Terminal
to AS. The main part number designation
NU2520/7-03
Positioner
remains the same, with the "M" prefix, such as
AU2520/23-01
Tool, Crimp
M81511/17-08. At times the entire item may be
M22520/23-02
Die Set
superseded by another. There are many cases
NU2520/23-04
Die Set
where documents have been cancelled without
M22520/23-05
Die Set
replacements, each case was reviewed and
M22520/23-09
Locator
some information has been retained in this
M22520/23-11
Locator
volume "for reference use only".
M22520/23-13
Locator
M81969/8-01
Tool, Insertion
3. DESCRIPTION. MIL-DTL-83723 connectors utilize
M81969/8-07
Tool, Insertion
crimp type contacts that are inserted, released, and
M81969/8-09
Tool, Insertion
removed from the rear of connector.
M81969/14-03
Tool, Insertion/Removal
M81969/14-04
Tool, Insertion/Removal
4. The entire assembly process is performed at rear of
M81969/29-02
Tool, Removal
connector so that the possibility of damaging critical
M81969/29-03
Tool, Removal
interface of connector is greatly reduced. This rear
M81969/29-04
Tool, Removal
release feature also permits the removal and installation
of any number of contacts without uncoupling
connector.
5. WIRE SEALING. Wire sealing is accomplished by
use of a grommet seal designed to seal against outside
diameter of inserted wire. The outer diameter shall be
within applicable size range as specified (Table 1).