33. CONNECTOR REMOVAL AND
INSTALLATION. If the connector is severely
damaged or cannot be repaired using the above
procedures, remove it as follows:
a. Starting from outside of damaged connector,
tag wires and remove all contacts from connector
(Paragraph 25). If contact cannot be removed, cut
wire as close to connector as possible and attach new
contact (Paragraphs 22 and 23).
b. Starting from center of new connector, insert
contact into correct cavity (Paragraph 24): Remove
tag from wire. Repeat procedure until all contacts are
installed in new connector.
35. For buildup procedures for solder contacts refer
to NAVAIR 0l-lA-505-1, WP 016 00.
36. CONNECTOR CLEANING AND
37. For connector cleaning and corrosion control
procedures refer to NAVAIR 0l-lA-505-1, WP 026