heated top of ammo floor. Use l/4-in. black
Locate on soundproofing behind Pilot's seat
centered between kit mounting studs. l&n.
letters and 200 in. white square.1/2in. xl
l/2-in.red cross, five 1/2-in.squares arranged in
a symmetrical cross centered on 2-in. white
background and below letters.
Left inside of gunner% armament control panel
DO NOT OPERATE TURRET
White letters on RED background. First line
WITH EITHER HYD SYSTEM
1/4-in. letters. Last three lines 3/16-in letters.
NOTE: Applicable on AH-1P and AH-1S.
On inside surface of panel assy adjacent to fwd
grenade dispenser. 1/2-in. Orange-yellow letters.
On inside surface of panel assy adjacent to aft
grenade dispenser. 1/2-in. orange-yellow lIetters.
To be located midway up and on the forward
edge of the doorframe. 1/2-in. black letters.
Arrow l-m. long with 1/8-in. shaft and 14-in.
Locate above and centered between minigun(s)
GUN WILL FIRE IF
and/or grenade launcher(s), orange-yellow let-
ROTATED BY HAND
ters. First line l-in. letters, last two lines 1/2-in.
NOTE Applicable on AH-1P and AH-1S.
Paint a 2 in. wide lusterless black stripe over
top of cowling toshow turbiue wheel location
in. forward from rear cowling.
NO HAND HOLD
Located right side aft of pilot's seat 1/2-in.
Authorized placement of unit insignia is on the
nose access panel using aircraft black
Servives Tranmission with
Locate inside on transmission pylon support
ML-L-23699 Oil Above -32C Ambient Temp
ease. Use 1/2-in. black letters.
MIL-L-7808 Oil Below -32C Ambient Temp
Both sides fuselage aircraft black
Figure 9-2. Exterior Marking, AH-1 (Sheet 9 of 10)