Top of fuselage, right side, fwd on access door, sta
152. Top of black letters facing outboard. Also right
side aft, sta 443.5 on CH-47 serial No. 66-19098
Top of fuselage, right side aft of walkway indent,
MAINT CRANE AZIMUTH PT.
sta 175. Also aft right side, of fuselage at sta 416.
REPLACE SCREW AFTER USING
1/2-in. black letters.
Three places on top of fuselage tunnel, sta 180,
303, and 384. Top of black letters facing left.
Top center of both sides of fuselage, sta 317. A
2-in. lusterless black circle on the fitting cover.
Top center of both sides of fuselage at fitting.
Stencil to be outbd of fitting, top of black letters
Top and bottom of left and right gear box access
cover. Top of black letters face aft.
Top of left and right engine pod drive shaft fairing.
Top of black letters facing aft.
On top of left and right nacelle on access plate. Top
of black letters facing aft.
Two places on top of left and right nacelle. Aft of oil
filler access and fwd of circular hole in fairing. Top
of black letters face aft.
Top of left and right engine nacelle, fwd of tail pipe.
Top of black letters facing outboard, arrows to point
OR HAND HOLD
On top sides of fwd and aft rotor blade rain shield.
Paint rain shield lusterless black (overspray rain
shield). Apply stencils 120 apart, 3 places on each
rain shield. This stencil is located outboard of each
rotor blade pitch link cutout hole
Figure 9-10. Exterior Markings, CH-47 (Sheet 25 of 29)