TM 55-2840-241-23
of the strainer. Repeat the procedure if visual in-
spection with a bright light shows that the interior
of the drainer is not entirely free of contaminates.
Be cure strainer (8) is installed as
shown in figure 5-8. Open end of
strainer toward the outside of the
control, away from the spring. Do not
install backwards.
(5) Install drainer (8), spring (9), and washer
(10) in filter sleeve (5). Secure components in the
filter sleeve with spring pin (6) and retaining clip
(7).
Use extreme care to insure that the
pneumatic lines and fittings are not
leaking. Erroneous pressures will
cause fuel control malfunction.
(6) Lightly lubricate a new preformed pack-
ing (2) with engine fuel and place it on plug (1). In-
stall filter assembly (4), spring (3) and plug (1) in
fuel control.
Change 4
5-12A/(5-12B blank)