TM55-2840-251-23
6-5
FUEL MANIFOLD ASSEMBLY (Continued)
6-5-1 REMOVAL (Cont)
CAUTION
Unless glow plugs remain installed, do
not attempt to remove all fuel manifold
adapter assemblies at any one time,
since seven of the assemblies serve to
locate the combustion chamber liner and
alignment problems may be encountered
at reassembly.
8.
Remove bolts and lockplates from remaining
manifold adapters and withdraw transfer tubes and
adapters. Remove and discard gaskets between
adapters and gas generator case.
NOTES
1.
If manifold assemblies are to be shipped
to an overhaul facility, or stored, they
must
be
individually
wrapped
and
securely packaged in a manner to
prevent their relative movement and
possible damage to orifice faces.
2.
If manifold assemblies are not to be
reinstalled in engine immediately, they
should be placed in a clean, covered
container to prevent exposure to dirt and
dust.
9. Remove and discard preformed packing retainer
(11).
GO TO NEXT PAGE
6-19