TM 55-2840-251-23
7-3 IGNITION REGULATOR (Continued)
7-3-4 REPAIR
Gasket
1.
Remove cover (Task 7-2-1).
2.
Remove gasket from box and clean off old adhesive
using Trichlorethane (E.46).
3.
Roughen bonding surface of box with Sand Paper
(E.84).
4.
Bond gasket to box with Adhesive (E.65). Insure
gasket joint is located at 6 o'clock position and slanting 30
degree cut is employed to effect joint. A 90 degree cut is
not acceptable.
5.
Allow to dry minimum two hours.
Springs
1.
Remove rivet (1), washer (3) and spring (2).
2.
Install replacement spring and secure with washer (3)
and rivet (1).
GO TO NEXT PAGE
7-12