PROPELLER SHAFT SEAL (AVIM) (Continued)
9-3-2 INSTALLATION (Cont)
Install garter spring (8) into vee-side of seal (7).
Gently press seal (7) into cavity in thrust bearing
cover (4) and work around with thumb pressure until
seal is correctly seated.
Locate retaining ring (3) or ring halves (3) on thrust
bearing cover (4) with split line on halves as close as
possible to horizontal plane, trapping gasket (6). Secure
with eight bolts and washers. Tighten bolts in
diametrical sequence, torque to 36 to 40 inch-pounds
and lockwire (E.5).
FOLLOW ON MAINTENANCE:
END OF TASK