TM 55-2840-254-23
2-62
ASSEMBLE OUTPUT SHAFT SUPPORT HOUSING (AVIM) (Continued)
2-62
Seal must be dipped in lubricating oil
before Installation. Failure to comply
will cause damage to seal.
1.
Install seals (3.1 and 3.2) in housing (3).
a.
Using the insertion tools (E36) and an arbor
press, press two seals (3.1 and 3.2 into the
housing.
b.
Dip top seal (3.1) in lubrication oil (E32 or
E33).
c.
Install top seal (3.1) with lip up in housing
(3) using top seal installation tool (E36) and
arbor press.
d.
Dip bottom seal (3.2) in lubricating oil (E32
or E33).
e.
Install bottom seal (3.2) with lip down in
housing (3) using bottom seal installation
tool (E36) and arbor press.
GO TO NEXT PAGE
2-484 Change 6