2-72 lNSTALL N0. 3 BEARlNG PACKAGE (AVlM) (Continued)
17. Remove alignment pins (T2).
18. Install ten bolts (24) and key washers (25) in
mounting holes of No. 3 bearing support.
19. Tighten bolts (24) in opposite pairs. Lock bolts
(24) by bending tabs of key washers (25).
Install Accessory Gear Assembly (Task 5-11)
Install Torquemeter Head Assembly (Task 9-14).
Install Torquemeter Junction Box (Task 9-5).
Install Output Shaft Support Housing
Install Overspeed Drive and Outlet Cover
Assembly (Task 5-23).
Install Tube Assembly (Inlet Housing to
Main Oil Pump) (Task 8-51)
Install Inlet Housing Cover Assembly
Install Output Shaft (Task 9-10).
Install Output Shaft Seal and Housing Assembly
Install Starter Drive Assembly (Task 5-16).
Install Fuel Boost Pump Assembly (Task 6-13).
Service Engine Oil System (Task 1-74).
END OF TASK