TM 1-1520-264-23
Figure 5-7. Engine Air Inlet V Band Clamp
5.7.3.6
Marking and Recording of Inspection Results. Mark and record the inspection results as required by paragraph
1.3.
5.7.4
Backup Method. None required.
5.7.5
System Securing. Clean the "V" band clamp to remove inspection media. Refer to Post Cleaning and
Restoration of Part or Area After NDI, paragraph 1.4.16. The "V" band, if removed, requires installation in accordance
with the applicable technical manuals listed in Table 1-1.
5.8 STARTER FLANGE (ET).
5.8.1
Description (Figure 5-1. Index No. 8). The air starter is located on the right upper side of the engine and is
mounted to the engine accessory drive case. It uses compressed air from the APU to turn the engine.
5.8.2
Defects. This inspection is used to verify crack indications found visually on the starter flange. No cracks are
allowed.
5.8.3
Primary Method. Eddy Current.
5-14