TM 1-4920449-13&P
3-23. Fixed Equipment/Components - Removal/installation
3-23
This tasks covers: Removal/Installation of fixed equipment/components
INITIAL SETUP
Tools
Shop Set, Tool Crib, NSN 4920-00-472-4183
Personnel Required:
68D Aircraft Power Train Repairer
REMOVAL/INSTALLATION
1. REMOVE/INSTALL FIXED EQUIPMENT.
NOTE
Permanently installed equipment should not ordinarily be removed or re-
located. However, in the event that it becomes necessary to remove, re-
install or replace fixed equipment within the shelter, care must be taken
to remove all bolts, washers and nuts and save them for reuse.
a Remove all bolts (1), lockwashers (2), washers (3)
and nuts (4) from shop equipment Remove equip-
ment.
b. Install new or repaired equipment If new equip
ment has different mounting brackets, remount
equipment as follows:
1. Mark new mounting location on bench tip.
2. Drill holes.
3. Align shop equipment
c. Install bolts (l), lockwashers (2) washers (3) and
nuts (4).
GO TO NEXT PAGE
3-33
