3-33
TM 1-4920-454-13&P
3-23. Fixed Equipment/Components - Removal/Installation
3-23
This tasks covers: Removal/Installation of fixed equipment/componenti
INITIAL SETUP
Tools:
Shop Set, Tool Crib, NSN 4920-00-472-4183
68B Aircraft PowerPlant Repairer
REMOVAL/INSTALLATION
1. REMOVE/INSTALL FIXED EQUIPMENT.
NOTE
Permanently installed equipment should not ordinarily be removed or re-
located. However, in the event that it becomes necessary to remove, re-
install or replace fixed equipment within the shelter, care must be taken
to remove all bolts, washers and nuts and save them them or reuse.
a
b.
c.
Install new or repaired equipment. If new equip
ment has different mounting brackets, remount
equipment as follows:
1. Mark new mounting location on bench top.
2. Drill holes.
3. Align shop equipment
Install bOltS (1), lockwashers (2) washers (3) and
nuts (4).
GO TO NEXT PAGE
