TM 55-2840-231-23
1-61. OIL CHANGEOVER PROCEDURE - Continued
ENGINE/-Continued
j. After five hours
operation, inspect and
clean or replace the oil
filter.
k. After 15 hours operation,
inspect and clean or
replace the oil filter.
l. Revert to normal
schedule of inspection
of oil filter.
1-62. ENGINE EXTERIOR SURFACE – CLEANING
INITIAL SETUP
Applicable Configuration
Consumable Materials
All
Drycleaning Solvent (item 1, Appendix D)
ENGINE/
Drycleaning solvent, P-D-680, type II
used to clean parts is potentially
dangerous to personnel and
property. Avoid repeated and
prolonged skin contact. Avoid
prolonged or repeated breathing of
vapors. Do not use near open flame
or excessive heat. Flash point of
solvent is 138oF (59o C).
Engine Exterior Surface
Flush or spray wash external surfaces with
petroleum solvent (item 1, Appendix D) to
remove grease, oil, and dirt. Insure that all
openings are plugged or covered before
cleaning.
Change 8
1-141
