TM 55-2840-251-23
Section VI SPECIAL INSPECTIONS (Continued)
1-32 EXPOSURE TO FIRE
EXTINGUISHING AGENTS
If engine is not operating and agent has not been
ingested, thoroughly clean outside of engine. If
agent has entered engine or engine was operating
at the time, compressor wash immediately
(Chapter 1, Section VIII) and return engine as
soon as possible to Depot.
1-33 HOT SECTION INSPECTION (AVIM)
If troubleshooting (Chapter 1, Section VII)
indicates hot section inspection, proceed as
follows:
NOTE
Before disassembly carry out
compressor wash and
performance check.
1.
Remove power section (Task 4-1-1).
2.
Remove fuel nozzles (Task 6-7-1).
3.
Remove glow plugs (Task 7-1-1).
4.
Remove combustion chamber liner (Task 3-1-
1).
NOTE
Prior to removal of compressor
turbine disk assembly measure
turbine tip clearance (Refer to Task
2-3-1).
GO TO NEXT PAGE
1-34
