TM 55-2835-251-23
Section VIII GENERAL MAINTENANCE PROCEDURES (Continued)
INITIAL SETUP
General Safety Instructions
Warning
Wash
hands
LUBRICATING
OILS
HAZARDOUS Lubricating Oils (E.2)
and (E.71) contain materials hazardous
to health. They can cause paralysis if
swallowed. Prolonged contact with
skin can cause irritation. Fire can
result if exposed to heat or flames.
Use only in areas with adequate
ventilation. thoroughly after handling.
Warning
TOXIC AND FLAMMABLE SOLVENTS
Solvents used for cleaning are toxic
and flammable. They irritate skin and
cause burns. Fire can result from use
near heat or open flames.
Use only in a well-ventilated area.
Wear rubber gloves. In case of
contact, immediately flush skin or
eyes with water for at least 15 minutes.
GET
IMMEDIATE
MEDICAL
ATTENTION FOR EYES.
NOTE
B&B 3100 (MIL-C-85704, Type I) is the
primary cleaner for Army turbine
engines and remains an approved
cleaner
for
locales
where
environmental
restrictions
permit.
Engine cleaners that conform to MIL-
C-85704, Type II and Type II are also
acceptable engine cleaners and meet
EPA
environmental
requirements.
Continue use of B&B 3100 where not
restricted. Where restrictions apply
use MIL-C-85704, Type II and Type IIA
cleaners. Approved Type II and Type
IIA
cleaners
shall
be
used
in
accordance with the existing washing
procedure. Type IRA cleaners do not
require dilution with water. Both types
of cleaners are less effective than
Type
I
cleaners.
Thereforemore
frequent
engine
washes
may
be
required
to
achieve
satisfactory
results.
GO TO NEXT PAGE
GO TO NEXT PAGE
CHANGE 1 1-80
