TM 55-2840-254-23
2-26 REMOVE STATOR VANE ASSEMBLIES (Continued)
2-26
NOTE
To help in installation, tag (E53) each stator
vane assembly as they are removed.
NOTE
Procedures for removing upper and lower
compressor housing stator vane assemblies
are the same. Instructions for removing lower
compressor housing stator vane assemblies
are given.
1. Remove Iockwire, eight bolts (1), and washers
(2) from bolt locations (3).
2. Remove one-half of first stage stator vane
(4) from lower compressor housing (5).
2.1. Remove RTV potting compound from outer
shroud (5.1) of stator vane (4) and from mount-
ing surface (5.2) of first stage stator vane (4).
Dry cleaning solvent (E17) is flammable
and toxic. It can irritate skin and cause
burns. Use only in well-ventilated area,
away from heat and open flame. In case of
contact, immediately flush skin or eyes
with water for at least 15 minutes .
Get
medical attention for eyes.
2.2. If necessary, remove excess RTV potting
compound from mounting surface (5.2) of first
stage stator vane using gloves (E20) and lint-
free cloth (E26) dampened in dry cleaning
solvent (E17).
2.3. Wipe dry using dry, lint-free cloth (E26).
GO TO NEXT PAGE
2-220
C h a n g e
5
