TM 55-2840-254-23
2-30 INSTALL STATOR VANE ASSEMBLIES (Continued)
2-30
Make certain that fourth stage vane is
installed with leading edge of vanes
facing forward. If vane assembly is in-
stalled wrong, the outer shroud will
protrude into airflow path. This may
cause unusual stresses on compressor
blades which could result in blade
failure.
4. Install one-half of fourth stage stator vane (17)
into compressor housing half (2).
a. Make certain that leading edge (18) of vane
faces forward.
b. Install six washers (19) aand six bolts (20) in
bolt hole locations (21). Finger tighten bolts
(20).
GO TO NEXT PAGE
2-243