TM 55-2840-254-23
2-31 REMOVE COMPRESSOR ROTOR BLADES (Continued)
2-31
Do not remove any parent metal from
inside retaining pin hole. Removing
material will enlarge hole. If this
happens compressor rotor assembly
will have to be replaced.
j. Clean out Iockpin hole (18). Use twist drill
(12). Remove tape.
NOTE
Fourth through seventh stage blades
shall be removed rearward.
3. Remove fourth through seventh stage compres-
sor blades (19)
as follows:
NOTE
Procedure to remove fourth through
seventh stage blades is the same. Re-
moval of seventh stage blades is shown.
GO TO NEXT PAGE
2-270