TM 55-2840-254-23
2-35
INSTALL COMPRESSOR ROTOR BLADES (Continued)
2-35
t.
Check engagement of lock-pin by reinserting bent
piece of lock-wire (16) used in previous step n. Insert
lock-wire (16) into slot in base of blade (1).
NOTE
Bend of wire shall protrude 1/16 inch from end of
blade when wire is bottomed on lock-pin.
INSPECT
u.
Inspect for (1) protrusion from disc. Protrusion at forward
face (22) shall not exceed 0.015 inch. Protrusion at rear
face (21) shall not exceed 0.010 inch.
INSPECT
GO TO NEXT PAGE
Change 6 2-331
