TM 55–2840–254–23
2–458 Change 7
2–54 CLEAN INLET HOUSING COVER ASSEMBLY
2–54
INITIAL SETUP
Applicable Configurations:
All
Tools:
None
Materials/Parts:
Dry Cleaning Solvent (E17)
Gloves (E 20)
Lint Free cloth (E 26)
Personnel Required:
68B10 Aircraft Powerplant Repairer
Equipment Condition:
Off Engine Task
Engine Oil System Drained (Task 1–75)
Output Shaft Seal and Housing Removed
(Task 2–48)
Inlet Housing Cover Assembly Removed
(Task 2–53)
General Safety Instructions:
WARNING
Dry cleaning solvent (E17) is flam-
mable and toxic. It can irritate skin
and cause burns. Use only in well–
ventilated area, away from heat and
open flame. In case of contact, imme-
diately flush skin or eyes with water
for at least 15 minutes. Get medical
attention for eyes.
1.
Wear gloves (E20). Clean inlet housing
cover assembly (1). Use lint–free cloth
(E26) dampened in dry cleaning solvent
(E17).
2.
Wipe dry using clean, dry lint–free cloth
(E26).
FOLLOW–ON MAINTENANCE
Inspect Inlet Housing Cover Assembly
(Task 2–55).
END OF TASK
