TM 55-2840-254-23
3-8
INSTALL COMBUSTION SECTION AND POWER TURBINE (AVIM) (Continued)
3-8
13. Remove hoist hook (12) and power turbine
fixture (T54) (11).
14. Inspect output shaft end play as follows:
a. Remove output shaft seal and housing assem-
bly (Ref. Task 2-48).
b. Install output shaft seal and housing assembly
(Ref. Task 2-52).
c. If output shaft end play is within limits, omit
following steps d. thru g. If output shaft end
play is not within limits, do following steps d.
thru g.
d. Remove output shaft seal and housing assem-
bly (Ref. Task 2-48).
e. Remove output shaft (Ref. Task 9-6).
f. Install output shaft (Ref. Task 9-10).
g. Install output shaft seal and housing assembly
(Ref. Task 2-52).
GO TO NEXT PAGE
3-127
