TM 55-4920-328-23P
Section I. INTRODUCTION
1. Scope.
This manual lists repair parts, special tools, test,
measurement, and diagnostic equipment (TMDE); and
other support equipment required for operation and
performance of Aviation Unit Maintenance (AVUM),
Aviation Intermediate Maintenance (AVIM), and depot
maintenance of the Test Stand, Aircraft Engine P/N
LTCT10465-02.
2. General.
This Repair Parts and Special Tools list is divided into
the following sections.
a.
Section II. Repair Parts List. A list of repair
parts authorized for use in the performance of
maintenance. The list also includes parts which must be
removed for replacement of the authorized parts. This
section is arranged by functional group, usually in
disassembly order, and listed in figure and item
sequence. Items are indented when required to indicate
the relationship to the next higher assembly. The
illustrations in this section will appear immediately
preceding each figure of text. Items which are not
assigned SMR codes appear for informational purposes
only and are not to be requisitioned.
b.
Section III. Special Tools List. A list of special
tools, TMDE, and support equipment authorized for the
performance of maintenance. This section is arranged in
figure and item number sequence. The illustrations will
appear immediately preceding each figure of text.
c.
Section IV. This section is divided as follows:
(1)
National Stock Number and Part Number
Index. A list, in ascending National Item Identification
Number (NIIN) sequence, of all National stock numbers
appearing in the listings, followed by a list, in alphameric
sequence, of all part numbers appearing in the listings.
National stock number and part numbers are cross-
referenced to each illustration figure and item number
appearance.
(2)
Supplemental National Stock Number and
Part Number Index. A supplemental list of all added or
changed National stock numbers and part numbers
presented in the same format as the National Stock
Number and Part Number Index. Supplemental National
stock numbers and part numbers are cross-referenced to
each illustration figure and item number appearance.
Refer to supplemental index before using basic index.
3. Explanation of Columns.
The following provides an explanation of columns
found in the tabular listings:
a.
Illustration. This column is divided as follows:
(1)
Figure Number. Indicates the figure number of
the illustration in which the item is shown.
(2)
Item Number. The number used to identify
each item called out in the illustration.
b.
Source, Maintenance, and Recoverability Codes
(SMR).
(1)
Source Code. Source codes are assigned to
support items to indicate the manner of acquiring support
items for maintenance, repair, or overhaul of end items.
Source codes are entered in the first and second positions
of the Uniform SMR Code format as follows:
Code
Definition
PA
Item procured and stocked for anticipated or
known usage.
PB
Item procured and stocked for insurance
purpose because essentiality dictates that a
minimum quantity be available in the supply
systems.
PC
Item procured and stocked and which
otherwise would be coded PA except that it is
deteriorative in nature.
PE
Support equipment procured and stocked for
initial
issue
or
outfitting
to
specified
maintenance repair activities.
MO
Item to be manufactured or fabricated at
Aviation Unit Maintenance (AVUM) level.
MF
Item to be manufactured or fabricated at
Aviation Intermediate Maintenance (AVIM)
level.
MD
Item to be manufactured or fabricated at the
depot maintenance level.
AO
Item to be assembled at Aviation Unit
Maintenance (AVUM) level.
AF
Item
to
be
assembled
at
Aviation
Intermediate Maintenance (AVIM) level.
AD
Item to be assembled at depot maintenance
level.
XA
Item is not procured or stocked because the
requirements for the item will result in the
replacement of the next higher assembly.
XB
Item is not procured or stocked. If not
available through salvage, requisition.
XC
Installation drawing, diagram, instruction
sheet field source drawing that is identified by
manufacturer's part number.
Change 4 1
