2-8.1 ADJUST INTERSTAGE AIR-BLEED ACTUATOR (WITH WATER WASH KIT
P/N 2-200-071-54 INSTALLED) (Continued)
Make sure bleed band pins do not bind
against actuator when piston moves to
closed position. Binding will not allow
bleed band to close properly.
Activate and release piston (15) several times,
Check that pins (23) are not binding. If pins
(23) are binding, reposition or replace pins (23).
14. With piston (15) in closed position, check
clearance between shaft of pin (19) and
bottom of slot (20). Clearance shall be 1/8 to
3/16-inch. Allow piston (15) to return to open
GO TO NEXT PAGE
C h a n g e