2-30 INSTALL STATOR VANE ASSEMBLIES (Continued)
f. Torque bolt (4) to 65 inch-pounds.
g. Check ends of bolts (4 and 7). Bolt ends shall
be flush or not more than 0.035 inch below
surface of stetor. If necessary, add washers
under bolt heads. There must be at least one
washer under each bolt had.
h. Calculate gap between stator vane shrouds as
outlined in step 8.
i. Lockwire bolts (4 and 7). Use Iockwire (E29).
GO TO NEXT PAGE