4-19 INSTALL FIRESHIELD SECTION (Continued)
Concave side of washer must face fire-
shield section. Failure to comply will
place wrong tension on internal oil tube.
Do not tighten reducer in following step.
Tightening of reducer may damage in-
ternal oil tube.
6. Remove reducer (10). Loosely install shim (12),
washer (13). concave side down, and reducer
Adapter must be held firmly when
tightening reducer. Failure to comply
will cause damage to internal tube as-
7. Hold adapter (11) with open-end wrench (T53)
(9). Torque reducer (10) to 115 inch-pounds.
GO TO NEXT PAGE