NAVAIR 01-1A-505-2
004 03
TO 00-25-255-1
Page 8
TM 1-1500-323-24-2
Figure 4. Strap Wrench Setup and Adjustment
b. Mate adapter tool to connector. Ensure white
b. Select the correct adapter tool, T-handle, and
dot on adapter tool aligns with master key of connector.
strap wrench (Tables 2 or 3).
Spinning tool on connector will cause damage to tool
and/or connector (Figure 4).
c.
Mate adapter tool to connector. Ensure white
dot on adapter tool align with master key of connector.
c.
Install strap wrench around part to be removed.
Spinning tool on connector will cause damage to tool
Draw strap tightly through locking link. Backshell will
and/or connector.
rest on nose of wrench.
d. Install strap wrench around part to be installed.
d. Insert T-handle into socket of adapter tool to
Draw strap tightly through locking link. Backshell will
provide holding.
rest on nose of wrench.
e.
To
loosen
backshell
apply
force
e.
Insert T-handle into socket of adapter tool to
counterclockwise as viewed from connector rear
provide holding.
(Figure 5).
NOTE
f.
Place backshell and associated hardware in
parts bag and secure to bundle to prevent loss.
Refer to NAVAIR 01-1A-505-1, WP 011 01, for
torque value information on AS85049 connector
15. BACKSHELL INSTALLATION. Upon completion
backshells.
of maintenance or modification the backshell must be
replaced. Proceed using the following steps:
f.
To tighten a backshell apply force clockwise as
viewed from connector rear (Figure 6).
a. Acquire the correct and associated hardware
and backshell. Start backshell on connector by hand to
prevent cross threading.
