NAVAIR 01-1A-505-2
005 03
TO 00-25-255-1
Page 5
TM 1-1500-323-24-2
CAUTION
d. Insert T-handle into socket of adapter tool to
provide holding (Figure 3).
Ensure white dot on adapter tool aligns with
master key of connector. Spinning the tool on
e.
To
loosen
backshell
apply
force
the connector will cause damage to tool and/
counterclockwise as viewed from connector rear
or connector (Figure 3).
(Figure 4).
c.
Mate adapter tool to connector, such that the
f.
Tape/secure backshell to bundle to prevent
white dot on the adapter tool aligns with master key
loss.
of connector. (Figure 3).
9. BACKSHELL INSTALLATION. Upon completion
d. Install strap wrench around part to be
of maintenance or modification, the backshell must be
installed. Draw strap tightly through locking link.
reinstalled. Proceed using following procedure:
Backshell will rest on nose of wrench (Figure 3).
a. Un-tape/retrieve stored backshell from
e.
Insert T-handle into socket of adapter tool to
bundle. Start backshell on connector by hand, to
provide holding (Figure 3).
prevent cross threading.
NOTE
b. Select correct adapter tool (Table 2, or 3), set
up T-handle and strap wrench (Figure 2).
Refer to NAVAIR 01-1A-505-1, WP 011 01, for
torque value information on AS85049 connector
backshells.
f.
To tighten backshell apply force clockwise as
viewed from connector rear (Figure 5).
Figure 3. Strap Wrench Setup and Adjustment