NAVAIR 01-1A-505-2
008 03
TO 00-25-255-1
Page 2
TM 1-1500-323-24-2
c.
Dummy Receptacles.
Support Equipment Required
d.
Dust Caps.
Part No./
Nomenclature
Type Designation
e.
Shrink Boots and Adapters.
BT Series
Adapter Tools
BT-BS-601
Wrench, Strap
f.
Conduit Fittings.
BT-BS-609
Wrench, Strap
BT-BS-611
Wrench, Strap
g.
Gaskets for Flange Mount Receptacles.
BT-BS-618
Wrench, Strap
BT-BS-625
Wrench, Strap
h.
Mounting Nut for Jam Nut Receptacles.
BT-BS-630
Wrench, Strap
BT-HT-107
T-Handle
i.
Rubber Bushings.
Materials Required
j.
Sealing Plugs.
Specification/
Nomenclature
k.
Potting Boots and Rings.
Part No.
A-A-52080 thru A-A-52084
Tape, Lacing
4. BACKSHELLS. Backshells are the most complex
P-2740FR
Tape, Silicone Rubber
connector accessories and simply stated they are any
4529670544
Tape, Silicone Rubber
device added to rear or wiring side of a connector.
Backshells may be divided into the following categories:
1. INTRODUCTION.
a.
Grommet Nuts.
2. This Work Package (WP) covers connector
accessories used with MIL-C-26482 Series 1 and 2
b.
Cable Clamps and Strain Reliefs.
connectors, their function, associated tools, assembly,
and procurement information.
c.
EMI/RFI Grounding Terminators.
NOTE
d.
Non-Environmental Backshells.
As all NAVAIR connector and accessory
e.
Environmental Backshells.
documents are transitioned to non-government
standards, the Society of Automotive Engineers
f.
Non-Environmental EMI/RFI Backshells.
(SAE), will become the preparing activity and
the Navy will adopt the documents, the
g.
Environmental EMI/RFI Backshells.
drawing number prefix will change from MS
to AS. The main part number designation
5. MIL-C-26482 SERIES 1 AND 2 CONNECTOR
remains the same, with the "M" prefix, such as
ACCESSORIES.
M81511/17-08. At times the entire item may be
superseded by another. There are many cases
6. SPECIAL TOOLS. Connector backshells come in a
where documents have been cancelled without
wide variety of types depending on application. To
replacements, each case was reviewed and
install backshells or accessories, adapter tools and a
some information has been retained in this
strap wrench are needed. Adapter tools (Figure 1) are
volume "for reference use only".
used to bold connector during backshell installation
and removal. Special tools are used to prevent damage
3. C O N N E C T O R A C C E S S O R I E S . C o n n e c t o r
to connector shells and accessories.
accessories are components added to a connector to
enhance its operational characteristics. These
7. ADAPTER TOOL SELECTION. To select proper
accessories are divided into the following categories:
tool, shell size, and type of connector plug or receptacle,
must be known. Select proper adapter tool (Table 1).
a.
Backshells.
b.
Connector Assembly Tools.