NAVAIR 01-1A-505-3
TO 1-1A-14-3
TM 1-1500-323-24-3
004 02
Page 2
Support Equipment Required
Part No./
Type Designation
Nomenclature
This document includes cadmium as a plating
material. The use of cadmium has been
MIL-I-81969/13-01
Tool, Insertion
restricted and/or banned for use in many
MIL-I-81969/11-01
Tool, Removal
countries due to environmental and health
06 1773 03
Tool, Polarizing
concerns. Consult applicable health an
MIL-I-81969/5-01
Tool, Insertion
environmental regulations regarding its use,
MIL-I-81969/4-02
Tool, Removal
handling and disposition.
MIL-C-22520/17-01
Tool, Crimp
Gardner-Denver Model 14BIAL
Powered Tool, Wire
4.
MIL-DTL-28731 CONNECTORS.
(or equivalent)
Wrapping
Standard Pneumatic 615-1
Powered Tool, Wire
5. MIL-DTL-28731 connectors are front release and
(or equivalent)
Wrapping
rear removable with crimp, wrap post, or solder contacts.
Cooper Tools 14YB3
Powered Tool, Wire
(or equivalent)
Wrapping
6. COUPLING. Connectors shall be capable of being
Cooper Tools 14HP1C
Manual Tool, Wire
fully coupled and uncoupled without use of tools.
(or equivalent)
Wrapping
Heat Sink
receptacle shall be accomplished by mechanical means
with protective shell, bosses, guide pins, sockets, or
Materials Required
jackscrews. See Figure 1.
Specification/
8. PART NUMBER. The following paragraphs
Part No.
Nomenclature
contain information necessary for proper selection and
procurement of the connector (Figure 2).
TT-I-735
Alcohol, Isopropyl
H-B-643 (or equivalent)
Brush, Acid
NOTE
Swabbing
MIL-F-14256 (or equivalent)
As all NAVAIR connector and accessory
SnGOWRMAP3 (or equivalent)
Solder
documents are transitioned to non-
government standards, (the Society of
1.
INTRODUCTION.
Automotive Engineers (SAE), will become
the preparing activity and the Navy will adopt
2. This Work Package (WP) pertains to connectors
the documents), the drawing number prefix
manufactured in accordance with MIL-DTL-28731.
will change from MS to AS. The main part
Repair procedures as well as ordering information is
number designation remains the same, with
included. The connectors are divided into three series
the "M" prefix, such as M81511/17-08. At
according to the manufacturer's series number.
times the entire item may be superseded by
another.
There are many cases where
3. DESCRIPTION. The connectors are rack and panel
documents have been cancelled without
mounted and can be used for other applications. They
replacements, each case was reviewed and
feature front release, rear extract removable crimp, wrap
some information has been retained in this
post, and solder contacts. The contacts are of the formed
volume "for reference use only".
blade fork type. A double wire crimp contact is available.
The operating temperature range of these connectors is:
9. Military Prefix. The prefix denotes military
-85F (-65C) to +257F (+125C).
standard. To determine the prefix refer to Table 1 and
Figure 2, such as: M28731/10-0109-C where
"M28731/10" is the military prefix..