NAVAIR 01-1A-505-3
TO 1-1A-14-3
TM 1-1500-323-24-3
006 02
1 September 2011
Page 2
Record of Applicable Technical Directives
None
a. G - General purpose, non-magnetic, high
Support Equipment Required
density, size 22, rear release crimp removable contacts.
Part No./
Type Designation
Nomenclature
b. P Environment resisting, potting type,
nonmagnetic, high density, size 22, rear release crimp
M22520/2-01 ...............................Tool, Crimp, Frame
removable type contacts.
M22520/2-34 .............................................. Positioner
c. E Environment resisting, nonmagnetic, high
M81969/1-04 ........................Tool, Insertion/Removal
density, size 22, rear release crimp removable contacts.
d. S - Solder termination, general purpose, high
Materials Required
density, non-removable size 22 contacts.
Part No./
Type Designation
Nomenclature
e. SE -Solder termination, environment resisting,
high density, non-removable size 22 contacts.
TT-I-735 or equivalent...................Alcohol, Isopropyl
H-B-643 (or equivalent).......... Brush, Acid Swabbing
4. WIRE SEALING. Wire sealing is accomplished by
MIL-F-14256 (or equivalent)...................Flux, Liquid
the use of B grommet seal designed to seal against
SnGOWRMAP3
outside diameter of inserted wire. The outer diameter
(or equivalent)............................................ Solder
shall be within the range specified (Table 2).
5.
MIL-DTL-28804 CONNECTORS.
1.
INTRODUCTION.
hex keys and shall be accomplished before engagement
2. This Work Package (WP) covers environmental and
of pins and sockets.
non-environmental polarized subminiature connectors
manufactured in accordance with MIL-DTL-28804.
7. PART NUMBER. The following paragraphs
These connectors are designed for -67F (-55C) to
contain information necessary for proper selection and
+257F (+125C) operating temperature (Figure 1).
procurement of connector (Figure 2).
NOTE
As all NAVAIR connector and accessory
documents are transitioned to non-government
standards, (the Society of Automotive
Engineers (SAE), will become the preparing
activity and the Navy will adopt the
documents), the drawing number prefix will
change from MS to AS. The main part number
designation remains the same, with the "M"
prefix, such as M81511/17-08. At times the
entire item may be superseded by another.
There are many cases where documents have
been cancelled without replacements, each case
Figure 1. MIL-DTL-28804 Typical Connector
was reviewed and some information has been
retained in this volume "for reference use only".
3. DESCRIPTION. The connectors covered by MIL-
DTL-28804 are classified according to the five following
classes (Table 1):