NAVAIR 01-1A-505-3
TO 1-1A-14-3
TM 1-1500-323-24-30
13 02
1 September 2011
Page 2
Alphabetical Index (Continued)
Subject
Page No.
Tooling ................................................................................................................................................................... 9
Coaxial Cable Stripping .................................................................................................................................. 9
Heating Procedures ....................................................................................................................................... 10
Holding Fixture Setup ................................................................................................................................... 10
Inspection...................................................................................................................................................... 11
Repair and Rework ....................................................................................................................................... 11
Record of Applicable Technical Directives
None
Support Equipment Required
Part No./
Type Designation
Nomenclature
DMC-216 .......................................................Tool Kit
This document includes cadmium as a
plating material. The use of cadmium has
Materials Required
been restricted and/or banned for use in
Specification/Part No.
Nomenclature
many countries due to environmental and
health concerns. Consult applicable health
TT-I-735 or equivalent
Alcohol, Isopropyl
and environmental regulations regarding its
H-B-643 (or equivalent)
Brush, Acid Swabbing
use, handling and disposition.
MIL-F-14256 (or equivalent)
Flux, Liquid
SnGOWRMAP3 (or equivalent)
NOTE
1.
INTRODUCTION.
Nickel plated parts are not for Navy or Air
Force use, or in new design.
2. This Work Package (WP) covers environment-
resisting, rectangular, stacked and panel mounted
4. MULTIPLE TERMINATION
connectors, manufactured in accordance with
CONNECTORS.
commercial MTC specifications (commonly referred
to as wafer connector), having pin and socket crimp
5. POLARIZATION. Polarization is accomplished
removable or solder, power, signal and coaxial
by the user inserting a key that aligns with the un-
contacts, for use with flat cable or round wire (Figure
keyed matting connector.
1).
6. PART NUMBER. The following paragraphs
3. DESCRIPTION. MTC rectangular connectors
contain information necessary for proper selection and
using jack screws, or quick disconnect hardware can
procurement of connector (Figure 2).
be stacked or panel-mounted next to each other
without any provision for grip space, a feature that can
7. Basic Vendor MTC Designation. The basic
save significant panel area. MTC connectors are
vendor MTC designation is denoted by MTC100.
available in 1-inch and 2-inch configurations. Modular
removable inserts with size 22 and/or size 16 contact
8. Mating Designation Number. Mating designation
cavities can be combined into the 1-inch and 2-inch
number denotes the mating style.
MTC housings.
