TM 1-1520-253-23
4.7.3.3
Access. Refer to Figure 1-4 and Table 1-2 to locate applicable access panels, doors, and fairings.
4.7.3.4
Preparation of Part. The components shall be thoroughly cleaned. Refer to Preparation of Part or Area for
NDI, paragraph 1.4.4.
4.7.3.5
NDI Equipment Settings. Refer to Bond Test Equipment, paragraph 1.4.6.1.
a. Attach cable and probe to Bondmaster. Protect probe with Teflon tape and install in probe holder.
b. Turn on Bondmaster, press SPCL, and make the following adjustments:
H Pos
- 40%
V Pos
- 80%
PHASE REF
-0
DRIVE
- MID
c.
Press SET and select DISPLAY - PHASE.
d. Place probe on the good area of test block and press GOOD PART. Do this several times while moving the
probe to different spots in the good area of the test block. Note the video signature for each. Select and enter a
representative good area by pressing GOOD PART one last time.
e. Place probe on void area of test block and press BAD PART. Do this several times while moving the probe
slightly to different positions within the void area. Select and enter a position that gives a strong difference between good
and void areas. (See Figure 1-5.) Use DIFF soft key to observe difference between good and bad areas of test block.
NOTE
If, during setup, the flying spot deflects upward or to the side when the probe passes over the
bad part, instead of the desired down deflection toward the alarm box, press SPCL and toggle to
a different phase setting (90, 180, or 270), and repeat steps d. and e. continue to try phase setting
until the flying spot moves in the desired down direction.
f. Place probe on good area of test block and press RUN. Flying spot should be near the top-center of the ACTIVE
screen. If not, press NULL. Slide probe from good to void area and note response from flying spot. This response
should provide both amplitude (vertical) and phase (horizontal) movement. The default gate/alarm setting may be
incorrect for this setup. Turn off or reset gate/alarm as desired.
g. The Bondmaster is programmed to automatically set test parameters to a start-up or initial bond test. By
following the steps outlined above, adjustments to the FREQ, GAIN, and ALARM can help to refine the selectivity in
locating defects among differing composite materials.
4-17
