TM 1-6625-476-30
7-5
Section II. DESCRIPTION OF TEST
Subject
Para
Page
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7-4
7-5
Test Concept . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7-5
7-5
Test Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7-6
7-5
Pretesting Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7-7
7-9
Final Acceptance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7-8
7-9
7-4. GENERAL.
This section describes the UUT test for the TV sensor, visual multiplexer, visual relay/multiplexer, and
solid state camera assemblies. It contains an explanation of the way testing is accomplished and a
description of the test.
7-5. TEST CONCEPT.
The UUT test is supplemented by procedures in section III of this chapter, and by illustrations in section
IV. While you are performing the UUT test, message prompts on the VDT will direct you to perform one
of the procedures in section III, or to refer to an illustration in section IV.
a. Procedures.Section III contains procedures to remove the TV sensor assembly and solid state
camera assembly from the shipping and storage container and to replace it in the container. These
procedures do not apply to the UUT test until called for by the test program. At the appropriate time
during the test, a message prompt on the VDT will direct you to perform a set of procedures in this
section. At that time, turn to the referenced paragraph and perform those procedures, as the program
cannot continue until they have been performed.
b. Illustrations. Section IV contains illustrations that supplement the UUT test procedures on the VDT.
The procedures cannot be successfully accomplished unless you refer to the appropriate illustrations
when directed by message prompts. In addition to showing you how to make an adjustment or locate a
component, many of the illustrations contain explanatory data, cautions relating to equipment damage,
and warnings relating to shock hazards. At the appropriate time during the UUT test, a message prompt
will refer to an illustration in section IV. Turn to the referenced illustration for assistance while performing
the following instructions on the VDT.
7-6. TEST DESCRIPTION.
When the UUT test program has run the selected self-tests and is ready to test the UUT, either the
vidicon tube or solid state camera test menu will be displayed on the VDT as shown below:
