TM 1-6625-476-30
2-22
2-11. TADS NSA INSTALLATION ON NIGHTSIDE TEST BENCH. (CONT)
WARNING
HIGH PRESSURE AIR
Ensure that pneumatic system is shut down. When pneumatic system is
inflated, E/O test bench set is capable of movement. If you try to mount
TADS NSA with pneumatic system inflated, personal injury or equipment
damage may occur.
NOTE
Remove handling fixture from TADS NSA before installing TADS NSA on
nightside test bench.
(6) Remove handling fixture as follows:
(a) Hold fixture (1, figure 2-13) in place and open locking lever (2) by lifting it up.
(b) Loosen thumb locknuts (3).
(c) Release clamp pad (4) by pressing down and holding clamp arm (5) near locking lever.
(d) Slide clamp arm toward locking lever as far as it will go.
(e) Carefully remove handling fixture from TADS NSA casting (6).
WARNING
HEAVY OBJECT
• Excessive strain can cause serious injury.
• Don’t: Attempt to lift or carry heavy objects alone.
• Do: Get help for lifting or carrying heavy objects.
• If you experience a sudden pain while lifting or discomfort after lifting, get
medical help at once.
NOTE
Two people are required when performing this task.
(7) Push sensor mount handle to unlock (away from operator) position. Lift insert/adapter and
TADS NSA by the handles of insert/adapter and aline numbered adapter guide pins (1, figure
2-14) with corresponding numbered holes (2) on sensor mount assembly (3). Ensure that
guide pin (4) on sensor mount assembly is alined with hole (5) on insert/ adapter.
