TM 10-4930-351-14
0080 00
INSTALLATION
1.
Attach D1 inlet elbow on hose end regulator.
a.
If removed, install O-ring (6), seal (7) and O-ring (8) on inlet elbow (5).
b.
Attach and hold together the inlet elbow (5) and the hose end regulator (3).
NOTE
To prevent loss of balls, place a suitable container under hose end regulator opening.
c.
Rotate the hose end regulator (3) and inlet elbow (5) back and forth allowing all 39 balls (12) to fall into the groove
as they are dropped in the hose end regulator (3).
d.
When all balls (4) are installed, position O-ring (2) and install screw (1).
2.
Attach hose end regulator to nozzle body.
a.
If removed, install O-ring (13), seal (14) and O-ring (15) in hose end regulator (3).
b.
Attach and hold together the nozzle body (11) and the hose end regulator (3).
NOTE
To prevent loss of balls place a suitable container under nozzle body opening.
c.
Rotate the nozzle body (11) and hose end regulator (3) back and forth allowing all 39 balls (12) to fall into the
groove as they are dropped in the nozzle body (11).
d.
When all balls (12) are installed, position O-ring (10) and install screw (9).
END OF WORK PACKAGE
0080 00-3/4 blank
