TM 10-4930-351-14
0080 00
REMOVAL-Continued
2.
Remove hose end regulator from nozzle body.
a.
Remove screw (9) and O-ring (10). Discard O-ring (10).
NOTE
To prevent loss of balls, place a suitable container under nozzle body opening.
b.
Hold the nozzle body (11) with the screw hole pointed down to allow 39 balls (12) to fall out.
c.
Rotate the nozzle body (11) back and forth allowing all balls (12) to fall out.
d.
Separate the nozzle body (11) and the hose end regulator (3).
e.
O-ring (13) and seal (14) should only be removed if damaged. If removed, replace both during assembly. Remove
O-ring (13), seal (14) and O-ring (15) from hose end regulator (3) and discard O-rings and seal.
5
6
7
8
1
2
4
3
13
14
15
12
10
9
11
0080 00-2