TM 10-4930-351-14
GENERAL SUPPORT MAINTENANCE
ADVANCED AVIATION FORWARD AREA REFUELING SYSTEM MODEL M100A1
REMOVE ENGINE FROM ENGINE MODULE
INITIAL SET-UP:
Materials/Parts Required:
Tools:
Plier, Diagonal Cutting
Wrench, Combination, 7/16"
Equipment Condition:
Screwdriver, Cross-Tip, Size 2
Engine module removed from pump-engine module
Screwdriver, Flat Blade, 1/4" x 4"
Personnel Required:
Drain Pan
Four
Wrench, Combination, 6 mm
Key, Socket Head Screw, 6 mm
Key, Socket Head Screw 3 mm
Wrench, Combination, 13 mm
Wrench Combination, 17 mm
Strap Wrench
1.
Place engine module high enough to allow oil drain pan to fit beneath oil drain plug.
2.
Remove either oil filler cap.
3.
Place oil drain pain beneath oil drain plug, remove the drain plug and drain the oil. Dispose of oil in accordance with
local SOP.
4.
Remove the oil filter, taking care not to spill oil from filter. Dispose of filter in accordance with local SOP.
5.
Install the oil drain plug.
6.
Cut and remove tiedown straps (1) from engine fuel supply line and engine fuel return line.
7.
Remove cable loop (2) from PTO end of engine.
8.
Remove screws (3) and nuts (4) from decompression lever (5). Remove lever (5).
9.
Remove cable clamp (6) from fuel flow solenoid wire cable at black start control knob (7).
10. Remove two socket head cap screws (8) and washers (9) securing cylinder casing (10) to cylinder heads. Remove casing
(10).
11. Place drain pan under fuel pump (11).
12. Remove fuel supply line (12) from fuel pump (11).
13. Remove fuel return line from fuel fitting (13) on #2 fuel injection pump.
0107 00-1