TM55-1500-345-23
dry sufficiently for flight in approximately four
b.
Apply first coat in continuous over-lapping
hours. Markings may be reapplied at any time
strokes. Going back over partially dried areas will
after the paint is dried.
cause excessive surface roughness.
c.
Allow first coat to air dry for approximately
Do not reapply black paint to anti-glare
e.
thirty minutes. Remove all dust and dry overspray
areas because MIL-L-46159 is sufficiently dark to
by lightly wiping with a lint free cloth and blowing
act as anti-glare. Application of heat resistant
with clean air. Apply second coat as in b above.
paint on the fuselage is not required.
After two coats, film thickness should be approxi-
mately 1.5 mils.
f.
When required, the low reflective paint
and epoxy primer may be stripped by applying
MIL-L-46159 will dry sufficiently to be
d.
touched in approximately thirty minutes and will
MIL-R-81294, remover, paint epoxy, and
polyurethane systems.
4-6
