TM 55-2840-251-23
Section X ENGINE TESTING
INITIAL SETUP
Applicable Configurations:
All
Test Equipment:
NSN 4910-00-167-9178
Tools:
Powerplant Mechanic's Tool Kit
NSN 5180-00-323-4944
Materials:
Lubricating Oil (E.2) or (E.71)
Lockwire (E.4) and (E.5)
Petrolatum Solvent (E.8)
Engine Fuel (E.19)
References:
TM55-4920-328-13
TM55-1510-109-10/2
Personnel Required:
68B Powerplant Mechanic
66G Aircraft Inspector
General Safety Instructions:
WARNING
LUBRICATING OILS HAZARDOUS
Lubricating
Oils
(E.2)
and
(E.71)
contain materials hazardous to health.
They can cause paralysis if swallowed.
Prolonged contact with skin can cause
irritation. Fire can result if exposed to
heat or flames. Use only in areas with
adequate ventilation. Wash hands
thoroughly after handling.
1-93. GENERAL
1. For testing engines installed in airframe, follow the
procedures in paragraph 1-94. Applicable TMs must be
used for engine trim adjustments and performance
checks when the engine is installed in the airframe.
Refer to related task for removal and installation of
pneumatic sense tubes when required during certain
checks in this section.
GO TO NEXT PAGE
1-133
