TM55-2840-251-23
3-1 LINER ASSEMBLY (AVIM) (Continued)
3-1-3 REPAIR (Cont)
2. Liner cracks not associated with burning, buckling, or
deformation must be repaired by stop drilling both ends of
crack, using 1/16 inch drill. Vee-out crack and fusion weld,
using Welding Wire (E.60).
NOTE
Do not dress welds on completion of
welding process. A copper backup plate
should be used to reduce distortion, with
recommended addition of inert gas.
3-1-4 INSTALLATION
Carefully install liner (1) into gas generator case (2)
aligning glow plug locating hole (3) with mounting boss (4).
FOLLOW ON MAINTENANCE:
Installation Fuel Manifold
Assembly (.Task 6-5-2)
Installation Power Section
(Task 4-1-2)
Installation Glow Plugs
(Task 7-1-5)
END OF TASK
3-10
