TM55-2840-251-23
Section II INNER (SMALL) EXIT DUCT, SHROUD AND VANE ASSEMBLY
3-2 INNER (SMALL) EXIT DUCT, SHROUD AND VANE ASSEMBLY (AVIM)
This task covers:
a.
Removal (3-2-1)
d.
Repair (3-2-4)
b.
Disassemble (3-2-2)
e.
Assemble (3-2-5)
c.
Inspection (3-2-3)
f.
Installation (3-2-6)
INITIAL SETUP
Applicable Configurations:
All
Tools:
Powerplant Mechanic's Tool Kit
NSN 5180-00-323-4944
Aircraft Inspector's Tool Kit
NSN 5180-00-323-5114
Torque Wrench (O to 100 inch-
pounds)
Grinder (T.16)
Spreader (T.46)
Wheel (T.52)
Materials:
Lubricating Oil (E.2)
Lockwire (E.4)
Petroleum Solvent (E.8)
Colorbrite Pencil (E.31)
Gloves (E.82)
Parts:
Vee-packing
Ceramic Cord
Slave Preformed Packing
Personnel Required:
68B Powerplant Mechanic
66G Aircraft Inspector
Equipment Condition:
Liner Assembly Removed
(Task 3-1-1)
Compressor Turbine Assembly
Removed (Task 2-3-1)
General Safety Instructions
WARNING
LUBRICATING OILS HAZARDOUS
Lubricating Oils (E.2) and (E.71) contain materials
hazardous to health. They can cause paralysis if
swallowed. Prolonged contact with skin can cause
irritation. Fire can result if exposed to heat or flames.
Use only in areas with adequate ventilation. Wash hands
thoroughly after handling.
GO TO NEXT PAGE
3-11
