TM 55-2840-254-23
2-21 CLEAN COMPRESSOR HOUSING (Continued)
2-21
NOTE
The following procedure applies to both
(upper and lower) compressor halves.
1. Wear gloves (E20), and clean compressor housing
(1) and stator vanes (2). Use fiber brush and dry
cleaning solvent (E17).
When using compressed air for cleaning,
use approved protective equipment for
eyes and face. Do not use more than 30
psig air pressure. Do not direct air toward
yourself or another person. Failure to
comply could result in injury to eyes or
skin. In case of injury, get medical
attention.
2. Wear goggles. Blow dry compressor housing (1)
and stator vanes (2) using clean, dry compressed
air.
FOLLOW-ON MAINTENANCE:
Inspect Compressor Housing (Task 2-22).
END OF TASK
2-145