TM 55-2840-254-23
2-60 CLEAN OUTPUT SHAFT SUPPORT HOUSING (AVIM)
2-60
INITIAL SETUP
Applicable Configurations:
All
Output Shaft Support Housing Removed
(Task 2-58)
Output Shaft Support Housing Disassembled
(Task 2-59)
Tools:
General Safety Instructions:
Powerplant Mechanics Tool Kit,
NSN 5180-00-323-4944
Goggles
Compressed Air Source
Materials:
Dry Cleaning Solvent (E17)
Gloves (E20)
Personnel Required:
68B10 Aircraft Powerplant Repairer
Equipment Condition:
Off Engine Task
Engine Oil System Drained (Task 1-75)
Output Shaft Seal and Housing Assembly
Removed (Task 2-48)
Inlet Housing Cover Assembly Removed
(Task 2-53)
Overspeed Drive and Outlet Cover Assembly
Removed (Task 5-17)
Output Shaft Removed (Task 9-6)
Dry cleaning solvent (E17) is flammable
and toxic. It can irritate skin and cause
burns. Use only in well-ventilated area,
away from heat and open flame. In case
of contact, immediately flush skin or
eyes with water for at least 15 minutes.
Get medical attention for eyes.
When using compressed air for cleaning,
use approved protective equipment for
eyes and face. Do not use more than 30
psig air pressure. Do not direct air toward
yourself or another person. Failure to
comply could result in injury to eyes or
skin. In case of injury, get medical at-
tention.
1. Clean oil filter element (1), bearing lube tube
assembly (2) and transfer tube (3) as follows:
Wear gloves (E20). Immerse oil filter element
(1), bearing lube tube assembly (2) and trans-
fer tube (3) in dry cleaning solvent (E17) and
agitate. Use brush on inner surfaces.
Wear goggles. Blow dry parts. Use clean, dry,
compressed air.
GO TO NEXT PAGE
2-478
