TM 55-2840-254-23
5-13 CLEAN STARTER DRIVE ASSEMBLY
5-13
INITIAL SETUP
Applicable Configurations:
All
Tools:
Powerplant Mechanic’s Tool Kit,
NSN 5180-00-323-4944
Materials:
Dry Cleaning Solvent (El 7)
Gloves (E20)
Lint-Free Cloth (E26)
Personnel Required:
68B10 Aircraft Powerplant Repairer
References:
Task 5-14
Equipment Condition:
Off Engine Task
Starter Drive Assembly Removed (Task 5-12)
General Safety Instructions:
Dry cleaning solvent (E17) is flammable
and toxic. It can irritate skin and cause
burns. Use only in well-ventilated area,
away from heat and open flame. In case
of contact, immediately flush skin or
eyes with water for at least 15 minutes.
Get medical attention for eyes.
NOTE
Before cleaning starter drive assembly,
check for evidence of oil leakage at
seals. If evidence of leakage is found,
have aircraft powerplant inspector in-
spect assembly (Ref. Task 5-14).
1. Wear gloves (E20) and clean starter drive as-
sembly (1) and gearshaft (2). Use dry cleaning
solvent (E17) and brush.
2. Remove any remaining solvent with clean lint-
free cloth (E26).
FOLLOW-ON MAINTENANCE:
Inspect Starter Drive Assembly (Ref. Task 5-14).
END OF TASK
5-85
