TM 55-4920-428-13
Chapter 2
OPERATING INSTRUCTION
SECTION I
U N P A C K I N
G
2-1. General. unpacking instructions are given in para 2-2. CHECKING UNPACKED EQUIPMENT IS GIVEN
in para 2-3.
2-2. Unpacking the Equipment.
a. Packaging Data. When packed for shipment, each unit of the ILCA test set is surrounded by
styrofoam cushioning material and placed in a cleated plywood box. A typical shipping box for each
unit and its contents is shown in fig. 2-1.
b. Removing Contents.
(1) Use a nailpuller to remove the nails from the cleated plywood cover and remove the cleated
plywood cover.
(2) Use the nailpuller to remove the nails from one side panel of the box and remove the side
panel.
(3) Remove the top and side pads of cushioning material.
The hydraulic unit weighs approximately 165 pounds. Be careful when
lifting the unit to prevent personal injury.
(4) Remove the test unit from the box.
2-3. Checking Unpacked Equipment.
a. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged,
report the damage as specified in para 1-2.
b. See that the equipment is complete as listed on the packing slip, Report discrepancies in accor-
dance with para 1-2.
c. If the equipment has been used or is reconditioned, see whether it has been changed by a modifica-
tion work order (MWO). If the equipment has been modified, the MWO number will appear on the
cover near the nameplate. If modified, see that any operational instruction changes resulting from the
modification have been entered in the equipment manual.
NOTE
Current MWO’S applicable to the equipment are listed in DA Pam
310-1.
2 -
1
Change 1
