Table 1-2. Access Panels, Doors, and Fairings - Continued
Aft landing gear
Aft ground test connections
Forward transmission hyd.module
Flight controls closet
Aft pylon mounting bolts
Hyd bay access
Aft transmission and blower
Radar warning receiver
Area between forward pod fairing and fuel pod
Area between fuel pod and aft pod fairing
To prevent injury to personnel and damage to helicopter, stand only on designated surfaces.
These areas are reinforced to withstand frequent use and are treaded to prevent slipping. All other
surfaces are NO STEP areas.
1.2.7 Steps. Handholds and Walkways Steps, handholds, and walkways aid
in performing maintenance, inspections,
and servicing on helicopters.
1.3. MARKING AND/OR RECORDING
OF INSPECTION RESULTS.
Only approved marking pencils are to be used for temporary marking of indications found during
an NDI inspection. The color of the marking shall contrast with the color of the part.
a. Wipe the area to be marked with low-lint cleaning cloth, MIL-C-85043.
b. Mark surface with appropriate color aircraft marking pencil, MIL-P-83953, using a light touch.