1.4.5 NDI General Safety Precautions.
Electrical equipment shall not be operated in areas where combustible gases or vapors may be
present, unless the equipment is explosion-proof.
Prior to conducting an NDI inspection, survey the general area in advance. Eliminate possible hazards created by loose
structures, protruding workstands, and support equipment. Secure loose electric cords and remove toxic fluids or fumes.
If AC power is supplied to equipment, be sure that equipment is well grounded to prevent electrical hazards. Specific
safety instructions for each NDI method used in this manual are contained in the paragraph immediately following the
discussion of that method.
1.4.6 Bond Testing (BT) Method.
Inspection of bonded structures shall be performed in accordance with the general applications
and techniques in TM 55-1500-335-23 (Nondestructive Inspection Methods manual) and the
specific requirements of this technical manual.
A number of different methods of NDI can be applied to the many configurations and types of bonded structures that are
in use. Variables such as skin material and thickness, adhesive type and thickness, underlying structure, and
accessibility are all factors in the development of specific inspection procedures. Because of the many inspection
methods and structural configurations, each application must be considered and reference standards representative of
the structure must be evaluated to verify proposed techniques.
220.127.116.11 Bond Testing Equipment. The bond testing equipment, Bondmaster, used
in the procedures
in this manual
operates by generating a mechanical vibration into the material being tested. This equipment is designed to detect flaws
in bonded metallic and composite structures. The instrument is capable of determining bad bonds, delaminations,
unbonds, and crushed honeycomb core defects. The Bondmaster has the following features:
a. Resonance. Detects unbonds and delaminations by changes in phase and amplitude at probe resonance.
Couplant is required.
b. Pitch Catch Swept. Measures amplitude and phase changes using a swept frequency method to detect unbonds
and deeper defects. Requires no couplant.
c. Pitch Catch Impulse. Measures amplitude and phase changes using a short burst of energy to detect unbonds.
Requires no couplant.
d. Mechanical Impedance Analysis (MIA). Measures the effect of generated sound waves and the effect of loading
as drive frequency is swept in the range of 2.5 KHz to 10 KHz. This method can be used on unbonds, crushed
core, and defects on the inside of composites. Requires no couplant. See Figure 1-5, Bond Testing Reference