Place probe on part in the required inspection location and null.
Adjust phase as required to obtain
Inspect the part.
Any signal similar to the notches in the test block is cause for rejection.
the ease of accessibility and user friendliness. If the probes are changed, steps
220.127.116.11 b. (1), (2), and (3) shall be repeated each time a change is made.
Marking and Recording of Inspection Results. Mark and record as required by paragraph 1.3.
3.7.5 System Securing. If removed, install the engine driveshaft in accordance with the applicable technical manual
listed in Table 1-1. Secure the engine driveshaft hinged panels.